Lever Piece Came Off Tower, HELP!

[MrZ123]

I was trying to clean my beer lines today for the first time and I fell into a bit of a problem.

While trying to unscrew one of my two beer levers, the whole lever piece unscrewed from the tower instead of just the lever itself. The second lever came off fine.

My issue is that my kegerator is installed in such a way that to take the tower off of the table top is a huge pain in the behind. Thus I need to somehow screw the lever piece back onto the bolt that is currently inside the tower around the beer line.

Is there any way to thread the lever piece into that bolt without taking off the whole tower?

[MeridianFC]

I'm not sure I understand. Did the whole faucet assembly come off:

Dual Tower (http://www.micromatic.com/draft-keg-beer/towers-pid-D4743DT.html)

Elbow shank assembly (inside tower) (http://www.micromatic.com/draft-keg-beer/taps-faucets-pid-4329A-3E.html)

[MeridianFC]

Or are you talking about a piece of the actual faucet?

Faucet (http://www.micromatic.com/draft-keg-beer/taps-faucets-pid-4933K.html)

Part #9 perhaps (look under replacement parts on that diagram)?

[MrZ123]

Thanks for the quick replies. It was the shank and I figured out that the top of the tower pops off, NICE TO KNOW! So then it was an easy fix. Thanks again.